UV DLP Projector Operation Manual

1. System Connection Procedure

Step 1: Software Configuration

Connect projector to PC via USB Type-B cable

Launch proprietary configuration software (download from Optical Prisms and Sensors and Modules Manufacturer | SICUBE (si-cube.com))

Set parameters:

UV intensity: 0-100mW/cm² (adjustable)

Step 2: Power Supply Integration

Verify voltage compatibility (12-24V DC ±10%)

Connect power cable to:

Projector input: 3-pin XLR (male)

Printer PDB: 24V terminal block

Current requirement: 6A sustained / 8A peak

Step 3: Video Interface Setup

Use provided HDMI 2.1 cable (1m length)

Connection path:

Projector HDMI IN (Type A female)

Control board HDMI OUT (19-pin)

Step 4: Control Protocol Link

Connect USB-C to printer's host port

Protocol specifications:

Baud rate: 115200

Command set: MODBUS RTU

2. Calibration Process

Step 5: Optical Alignment

Power on system (warm-up time: 90s)

Place calibration paper at build plate

Rotate focus ring (±15° adjustment range)

Verify sharpness with test pattern

Step 6: Print Initialization

Load print file (.photon format)

Confirm resin tray installation

Start sequence:

UV shutter open

Layer projection begins

Z-axis movement initiated

3. Safety Indicators

✔ Green LED: Normal operation

⚠ Yellow LED: Cooling active

✖ Red LED: Fault condition

4. Compliance Standards

CE EN 62471:2008 (UV safety)

FCC Part 15B (EMC)

RoHS 3 (2015/863/EU)